Ruger Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
569 Posts
Discussion Starter · #1 ·
I just traded for a vintage '77-date M77 Mk.I with the tang safety. During my disassembly and cleaning, the safety spring coil doesn't appear to be attached or affixed to anything other than being stuck into a small hole of the end of the trigger housing roll pin. Is this correct? Anything to be concerned about?
 

Attachments

·
Registered
Joined
·
12 Posts
I just took my M77 Tang safety stock off... my assembly looks like yours... I would check the spring out, especially where it goes into the hole.... the rust may have eaten away the part you cannot see
 

·
Registered
Joined
·
569 Posts
Discussion Starter · #3 ·
Does it just stick down into the roll-pin hole? It works fine, nice strong return "thunk" on the safety working back and forth, but am concerned about the rust.
 
1 - 3 of 3 Posts
Top