Ruger Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hi folks,

Before I ask my question I did search extensively on this topic in the forum and apologize in advance if there is an existing thread on this topic. I own a .44 mag carbine with the tubular magazine. Does anyone know if there is a write up on how to disassemble the magazine tube? I want to replace the mag spring and cannot get the end cap on the only end that disassembles to come off. The factory manual does not go into detail as to how to disassemble the mag tube. There is a pin that protrudes from a hole near the in the mag tube right below the cap that in my mind should be spring loaded and when depressed through the hole in the mag tube should release the cap at the end of the tube and allow the spring to come flying out. The pin I am referring to wont budge on my mag tube and before I try to convince it to move I thought I would reach out to you all smart folks for help. Thank you in advance!
 
1 - 2 of 2 Posts
Top