Ruger Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
HI has anyone come across a one piece rail to fit a ruger 77mk11 in their travels,
anyway i have a 77 with the stepped receiver but have run out of windage with my scope i’m 1.5 in right at 50m and have no windage left left i don’t really want to have to shim the thing, therefore if i could find a good rail setup i’d bite , there is a two piece weaver adapter out there, but a one piece would be preferable , any help or pointers gratefully received
rifle is a 77 with a walther barrel and timney trigger,bedded boyds stock
scope is a s&b 4-16x50 ph
 

·
Retired Moderator & Gunsmith
Joined
·
17,798 Posts
landkeeper, In all probability, your rings are not seated properly in the receiver notches. This is quite common with Ruger rings. I would recommend removing the scope and rings then dress the ring bases and receiver notches with a fine file. Likely you will find a burr or obstruction that prevents proper seating.
 

·
Registered
Joined
·
67 Posts
1 - 3 of 3 Posts
Top