Ruger Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
81 Posts
Discussion Starter #1
Hello and Merry Christmas

I have just a quick question.

I loaded some 7mm-08 loads last night. I put 40 grains of 4064 and a Hornady 139 grain bullet into a Winchester Case and I used CCI 200 small rifle primer. The data in the Hornady manual called for Remington cases and Remington primers.

I test fired it and did not get any pressure signs that I could tell except the primer was flat.

In your opinion should I dismantle these loads and use a smaller charge and work up from a lower point.

Thank you
 

·
Registered
Joined
·
658 Posts
Find or send a note to GunBlue on this forum. He has done a lot of work on this load and will have some good info for you. He sent me a recipe on it.
 
1 - 2 of 2 Posts
Top