[ajohannsen]

I have a P91 with a scared up and I believe bent guide rod. I believe bent due to fact that during reassembly if not turned just right, slide will only open about 3/4 of the way. I have tried searching forums and web for replacement with no luck. I found lots for other P-series, are any of these interchangeable or am I stuck trying to find a gunsmith/machinist to build one?

Thanks for any advice.

 

[RugerAR]

contact Ruger,

do you have a manual? the part and number should be in the manual. and I am sure Ruger could send/sell a replacement.

 

[RevolverGuy]

These guys sell all steel rods. I assume the ones for the p89 will fit the p91.
Ruger Products - Stainless Steel Guide Rods