Ruger Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
6,529 Posts
Discussion Starter #1
Kinda bored this evening so I figured I'd install the older VQ action kit I received today in one of the trigger assemblies sitting idle. As factory, trigger pull measured between 5.24 and 6.10. 10 minutes later the new parts produced a measured trigger pull of 2.10 - 2.15. This was just a change of the hammer and sear and just for the fact they were included, the hammer and sear shims. Did not use the hammer or trigger return springs - never do.
Pretty happy with the results. No idea where the assembly will end up but it's there when needed. Got a couple others already reworked just sitting idle too so this one is by no means a hurry-to-get-done thing. Still not as nice of a feeling as the Kidd kit but again, pretty happy with the results. :)
 
1 - 1 of 1 Posts
Top