Ruger Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
72 Posts
Discussion Starter #1
Hello all,
Can someone tell me if the Bushnel Banner 3x9 scope will fit on my mini 14 Tactical with the Ruger rings that came with it?
Not looking to spend a loy right now and if this will mount up with the rings that came with it, will be ok with me for right now, at least. I believe the rings that came with it are 1 inch.
Also, soes anyone know what the 4 little strips that came with the rings are for?
No instructions at all with the parts. Thanks much.
Doug in n.e. Pa.

Bushnell Banner Rifle Scope 3-9x 40mm Long Eye Relief Multi-X Reticle
 

·
Reloading Addict
Joined
·
10,714 Posts
It tells you in the scopes tech. info that the tube diameter is 1", so yes the scope will fit 1" rings.
 

·
Registered
Joined
·
173 Posts
Here is a spot of their website for figuring ring height.
http://shopruger.com/searchscopering.asp
Where the drop-down box says "family", follow the prompts for your model.

Should have a number stamped on the ring, corresponding to the height.
My experience is that the rings they ship have liberal height for 40mm obj scopes.

Also, Ruger is very gracious about swapping "new-in-the-package" rings for a different height and no charge, other than your shipping cost to send yours in.

Rings usually come with thin stips, similar to electrical tape, to go between the scope and ring, so it doesn't scratch the scope paint. I 'm guessing thats the strips you are asking about.
 
1 - 5 of 5 Posts
Top