Ruger Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
51 Posts
Discussion Starter #1
Can anyone tell me, are the CTC grips "sighted in" when they are factory installed?
 

·
Retired Moderator & Gunsmith
Joined
·
16,471 Posts
Don't know but you can zero the laser without firing a shot. Just align the dot with the iron sights at 15-25 yards and you will be very close.
 

·
Registered
Joined
·
51 Posts
Discussion Starter #3 (Edited)
Update:

Distributer sent the wrong gun, was with hammer spur not spurless as ordered. But did check the CT grips, looked to be about 4" low and 9" to the right sighting at 75 feet, definitely not centered over the front site at that distance.

Incase anyone was curious. I should have a chance tomorrow to pickup the right gun. It'll be interesting to see if there is any consistancy. Looks like they only check the gun with iron sights.

The correct order came in yesterday. This time the CT grips look a lot closer to the point of aim at 25 yards. I"ll definitely take it to the range this weekend. Put some rounds through it and adjust the laser if necessary.

Thanks
 
1 - 3 of 3 Posts
Top