Ruger Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
30 Posts
Discussion Starter #1
I have a 20 year old GP 100. I finally took those grips off for a set of rubber Houges. So under one of the wood insert was this 1/2 inch long on that just sits inside a precut slot.
What the hell is that pin for?
 

·
Ausmerican.
Joined
·
42,767 Posts

·
Registered
Joined
·
168 Posts
Basically it goes into the hammer spring linkage to take it apart.

This is covered in the manual on how to take it apart and also shows as video on ruger.com.
 

·
Ausmerican.
Joined
·
42,767 Posts
1 - 6 of 6 Posts
Top