Ruger Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter #1
Can you tell me the size and maybe the length (I can measure that later) of the two screws near the hammer that hold the grip frame on a NM Blackhawk?

Are all five screws the same size? Thanks ahead of time. SRM out!
 

·
Retired Moderator & Gunsmith
Joined
·
16,471 Posts
All five screws are the same size and thread pitch but there are 4 different lengths. The front screw is short. The two screws by the hammer are the same medium length. One of the screws that is vertical behind the trigger guard does double duty and holds the hammer pivot pin in place. It is longer than the other vertical screw.
 

·
Registered
Joined
·
16 Posts
Discussion Starter #3
Thanks! I guess I am asking about the threads on the screws: 6x48 or 6x40? Did I say that right? SRM out!
 

·
Retired Moderator & Gunsmith
Joined
·
16,471 Posts
SunRiverMan, All 5 screws are 6X40 (#6 screw, 40 tpi).
 

·
Registered
Joined
·
16 Posts
Discussion Starter #5
Why thank you! That's what I've been wondering. SRM out
 
1 - 5 of 5 Posts
Top