Ruger Forum banner

Grip frame... where oh where??

1817 Views 11 Replies 7 Participants Last post by  rugerguy
I have a factory satin stainless steel grip frame I picked up awhile back with the idea of putting it on my blued .32 mag Single-Six.

But I'd like to get it bead blasted or something to give it a softer look.

Anyone know where I can send this off to for such a service?? Also, how much, approximately, would this cost?

Thanks! :)
1 - 2 of 12 Posts
If you lived near me I could it done for nothing. It should not be over a hours labor charge in any shop. Around $16.00. It takes about 15 to 20 mintues to do.
Hey RugerGuy is there a reason for the Red scotchbrite,and do you wet them or use them dry? .....Thanks Baldy...
1 - 2 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.