Ruger Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
30 Posts
Discussion Starter #1
This might be old hat for some but I wanted to post an FYI if anyone else has the same situation. When I tried to install my scout scope on the QRW mounts, the top ring was a hair too small. The inside diameter opens up to an honest 1.0 inch. Actually my calipers said .99.
I didn't want to force it and double checked the part number etc. I finally found a thread in the Marlin forum that said it snaps in place. I was still worried about scratching my new Leupold so I used a piece of thin paper, a sales receipt, on each contact point.
It worked like a charm! Still all pretty
 
1 - 1 of 1 Posts
Top