Ruger Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
i have older 10/22 s/n indicates '73-74 vintage. were there changes somewhere to mags or magwell dimensions? older mags fall free newer ones don't, have to be pushed out from top. any ideas?
 

·
Registered
Joined
·
159 Posts
I'm sure the molds have been replaced many times, and tolerances may have changed. Just sand the inside of the stock where the "magwell" is defined with 220-grit paper on a block. It doesn't take much to provide the required clearance.
 
1 - 2 of 2 Posts
Top