Ruger Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter #1 (Edited)
Mini-14 scope mount ID

Got this non ranch model one piece scope mount at a gun show. Looks to be silver anodized aluminum. Mounts with side screws in place of the rear sight assembly with a vertical tensioning set screw at the rear.
Anyone have an idea on the make?
If anyone has one, is it supposed to have some sort of anti-scratch piece between the front part and the receiver?

ScopeR - Ruger Forum
ScopeL3 - Ruger Forum
 

·
Retired Moderator & Gunsmith
Joined
·
16,471 Posts
That's a Wichita base ... a pretty good one too. You can put a piece of flat stock between the front screw and the receiver to keep it from marring. I cut a piece out of a gap gauge blade for mine. Works great and stays tight.
 
1 - 2 of 2 Posts
Top