Ruger Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
48 Posts
Discussion Starter · #1 ·
I am planning on ordering a Meprolight night sight for my SP101, and needed to check to see if it is much taller than the factory sight. Only reason I ask is that I have a holster on order with R. Grizzle Leather, and wanted to make sure the sight channel in the holster is big enough.

Thanks in advance!
 

·
Ruger Tinkerer
Joined
·
11,901 Posts
I doubt it will matter but I say that based on my own experiences - can't promise yours will be the same. I put a Meprolight on a SP101 and the owner happily put it back in the same Bianchi holster as before. I put a XS small dot on my SP101 and it fit fine in my Kelley Gunleather holster. Both were 3" models and both holsters were full coverage holsters. Didn't seem to matter at all.
 

·
Wandering Sandlapper
Joined
·
3,281 Posts
I have a Mepro on an SP101. It is slightly higher than the stock ramp sight.

Not so much that it is likely to hamper the fit with the holster, but it will slightly alter your Point of Aim.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top