Ruger Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Hey all -
During my wait period for my 10/22 Takedown, I picked up a few goodies - one of which was a swivel-stud bipod.
I noticed that the Takedown does not have one and from what I've read, putting a swivel stud on a plastic stock will not be good.

Are there any other ways I can get this bipod on there? I don't want to get another bipod (like a picatinny one).

I did some searching and had no luck finding a barrel band swivel stud... any other suggestions?
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #3 ·
thanks red.
Yea the plastic wall for the stock seems pretty thin and I agree that the force to open c/ close the bipod would do damage fairly quick.

I may do what some others have done and cut an aftermarket stock and drill out the right holes for the takedown mechanism but man, sounds like a lot of work that may end up not looking so good...
 
1 - 2 of 2 Posts
Top