Ruger Forum banner

Status
Not open for further replies.
1 - 20 of 37 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hello all. Looking for advice. I finally got my 6.5 creedmoor Ruger VT. Usually when I buy a new rifle I just go shoot it. After some research I heard you need to break your barrel in correctly. Wondering what is the recommended practice for this? Also curious about what kind of accuracy I can expect from shooting factory 129 SST's? Any advice is greatly appreciated.
 

·
Double P90 Shooter
Joined
·
19,890 Posts
Welcome from the Republic of Texas...You may want to look for more info in the "Ruger Rifle" section to get some better answers.
 

·
Registered
Joined
·
10,286 Posts
Welcome to the forum
 

·
Registered
Joined
·
8,193 Posts
Welcome to the forum from PA!

I have always done the following for barrel break-in. Clean it when I get it home, go to the range and sight it in, and clean it when I get it home. Repeat as needed depending on use.
 

·
Registered
Joined
·
7,654 Posts
Welcome from Wisconsin
 

·
Registered
Joined
·
7,847 Posts
A big welcome to the forum from Georgia!!
 

·
Life is good
Joined
·
4,866 Posts
Welcome to the forum.
 

·
Registered
Joined
·
17,256 Posts
Welcome from the Texas Panhandle.
 

·
Registered
Joined
·
2,954 Posts
Welcome from Central Florida.
 
1 - 20 of 37 Posts
Status
Not open for further replies.
Top