Ruger Forum banner
Status
Not open for further replies.
1 - 20 of 28 Posts

·
Registered
Joined
·
35 Posts
Discussion Starter · #1 ·
Hello everyone.
I've been reading post here for about 6months and finally joined.
It seems like there is a lot of good advice. So I've been wanting to try to engrave a slide but don't want to screw up and have a ugly gun. Can I buy a slide for one of my sr pistols? And if so where can I find it? Thanks
 

·
Double P90 Shooter
Joined
·
19,890 Posts
Welcome from the Republic of Texas...
 

·
Registered
Joined
·
3,731 Posts
Welcome from Wonderful Wyoming.
 

·
Registered
Joined
·
1,845 Posts
Welcome to the forum - from "The Mountain State"
 

·
Retired Moderator & Jazz Nerd
Joined
·
16,351 Posts
Jmoore ... Welcome from a fellow Buckeye in SW Ohio ... Glad to have you aboard!
 

·
Ausmerican.
Joined
·
42,767 Posts
Welcome from Australia mate.
Glad to have you on board, nice folk here and lots of good info.
 

·
The Shooterologist
Joined
·
3,992 Posts
Welcome from Louisiana........
 

·
Registered
Joined
·
2,380 Posts
giday from down under bloke
 

·
Ruger Tinkerer
Joined
·
11,898 Posts
Hello and welcome from SW Florida. Start with a phone call to Ruger customer service. Also post a new thread with your question in the Ruger Pistols forum here and you will get better feedback. Good luck!
 

·
CARSON-WEST - 2016
Joined
·
6,784 Posts
Welcome, fellow Buckeye. As stated above, please post this in "Ruger Pistols" instead of New Users and you'll get more people who can help you. But, for just a slide I'd start off by contacting Ruger if you haven't already. I can't recall seeing any SR slides for sale recently.
 

·
Registered
Joined
·
4,164 Posts
Welcome from Georgia.
 

·
Registered
Joined
·
3,128 Posts
Welcome from mid-coast Maine.
 

·
Registered
Joined
·
10,286 Posts
Welcome to the forum

Call Ruger customer service and ask.
 

·
Registered
Joined
·
1,231 Posts
Welcome; I agree with the advice given on contacting Ruger first, the post a thread in the pistols forum...
 
1 - 20 of 28 Posts
Status
Not open for further replies.
Top