Ruger Forum banner
1 - 1 of 11 Posts

· Registered
Joined
·
954 Posts
When I torque the stock screws on my CZ455 to the Boyd's stock, the bolt will not operate, as the rear screw interferes with its operation. I will have to shorten the rear screw; additionally, I had to do some inletting to provide adequate barrel float. I think this is not unusual for aftermarket stocks.
Anyone else have a similar experience with Boyds stock???
Not sure if I need to do a bit of inletting of just call Boyds and say it does not fit correctly
 
1 - 1 of 11 Posts
Top