Ruger Forum banner

1 - 3 of 3 Posts

·
Squirrel Sniper 1st class
Joined
·
254 Posts
Discussion Starter #1
ok i searched though previous posts, read the manual, and haven't come across how the safety lever comes off.....

i am going to be polishing my slide, but this one little obstacle is in the way, can anybody clue me in or have a "how to" to direct me to....?

thanks in advance.....
 

·
Squirrel Sniper 1st class
Joined
·
254 Posts
Discussion Starter #2
alrirght folks, i figured it out...... damn good design but not good enough for don peyote.....
 

·
Registered
Joined
·
1,015 Posts
For those that come after looking for the info:

Use a small flat screwdriver to pull the extractor forward and out. This will free up the safety levers to come out of the frame. Right side first, then left. Then you can remove the firing pin and spring.

pretty much the same deal on all the P-series guns up until the P345. That's where it got a little funky :D.
 
1 - 3 of 3 Posts
Top