Ruger Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
I just received my new Ruger PC Carbine chassis model 19122, after checking the rife, I noticed that the muzzle end of the barrel is off center of the handguard. I understand barrel needs to set higher in the handguard to line up with the receiver . But, when you look at mine seems to nearer to the right side of the handguard. Anyone else with model have the same problem ? Thanks for any help or info.
 

·
Righteous Dude
Joined
·
21,487 Posts
I've seen carbines at shops with that same issue (I most remember seeing that at Bud's). Seems to me it's not uncommon. I wonder if you can't reset the handguard to sit more centered. Shims may even help.

My Midwest Industries rail sits centered on mine, so I haven't had to do any tweaking.
 

·
Registered
Joined
·
43 Posts
Barrel alignment

Agreed ! The barrel has less clearance on the left side. About a 0.036 larger gap on the right side. Nothing in the manual regarding hand-guard / barrel alignment. Will be calling CS in the morning.
 
1 - 3 of 3 Posts
Top