Ruger Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I am trying to reinstall my hammer after sending it to Galloway for a mod. I pulled my punch too far and the safety detent pin in the ejector housing dropped down. What kind of tool will I need to Push that little spring loaded pin back up so I can install the hammer and hammer pivot pin? Thanks for your help.
Dan
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top