Ruger Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
6,926 Posts
Discussion Starter · #1 ·
Decided to remove my Tasco rimfire scope for a different challenge next range trip.

Was not too surprised to find that the Weaver T-09M mount left some shiny spots on the dull black receiver finish. I cleaned the surface well with naptha and rubbing alcohol, then got brave with some red Scotchbrite.

With some gentle rubbing, the shiny places disappeared okay. The finish is pretty tough. I know eventually this treatment would go through to bare aluminum, but it's nice to have it restore at least once.

I put the filler screws back with a little blue Loctite, and it looks 99% new.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top