[Snuffy]

Wow I have been busy replacing the grip frame on my Black Hawk what a labor of love. The hole for the grip pantel dowel is crooked. I didn't notice this until the other day when I was getting ready to put the gun back together. I got the brass blank from brownells. And they are good folks, I have filed and shaped it so I doubt if they would replace it, beside I got alot of labor in this grip frame as it is. I sure don't want to start over again.
A friend of mine is a jewerl and is going to see what he can do to fit it. I sure hope he can.

 

[Maxx Load]

Snuffy, there's always a way, no worries. Maxx Load

 

[Maxx Load]

BTW Snuffy, I take it you got from Brownells, can you help a computer dummy find a link to this place. I really wants to put a brass gf on my om 357. Thanks.
Maxx Load

 

[jimbo1096]

That's an easy one:

www.brownells.com

Think I read somewhere that Ruger was selling off some extra stainless grip frames. And that MidwayUSA also had the brass frames but I'll not swear to it.

 

[Maxx Load]

Thanks I found it. Maxx Load

 

[Snuffy]

sorry I didn't make it back in tiume pal but jimbo1096 was there to help out thanks jimbo.

 

[J Miller]

Use brass rod, weld it up and redrill it.
It's a PITA when something is crooked and don't see it till you altered or fit the part.

Joe

 

[Snuffy]

thanks I got it to work trimed the hole in the grip panel. But I'll remember about the brass rod for the next time.