I'd like to swap out the safety switch of my RPR for one that is ambi..
There is hope that with an ambi switch that there being a lever on each side will allow me to shim the safety assembly to tighten up some of that annoying wiggle.
From what I can gather, a 45 degree AR safety has an extra pin in the barrel that is meant for an additional cutout to the receiver hole opposite the detent groove (on the -single- lever side).
A 60 degree switch doesn't utilize the extra pin.
My question is: Is this receiver meant for a 45 -or- 60 degree swing safety assembly?
There is hope that with an ambi switch that there being a lever on each side will allow me to shim the safety assembly to tighten up some of that annoying wiggle.
From what I can gather, a 45 degree AR safety has an extra pin in the barrel that is meant for an additional cutout to the receiver hole opposite the detent groove (on the -single- lever side).
A 60 degree switch doesn't utilize the extra pin.
My question is: Is this receiver meant for a 45 -or- 60 degree swing safety assembly?