Ruger Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter · #1 ·
I have taken apart and reassembled a few times and always seem to have the same problem.

When replacing and "closing" the bolt stop pin assembly, the pin rides a little out making closing the mainspring latch impossible. I always futz around with it a bit and have always been able to eventually close the latch. I think I am missing something, are there any tricks? I have and use the instructions from http://www.guntalk-online.com/fsprocedures.htm
I also have Iowegan's book but always seem to get stuck in that area.

Thanks all in advance.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top