I took off the quarter rib to my No.1 RSI to take a look at some possible accuracy issues and noticed that it has a pretty good bow to it. The bow is in such a way that if you screw down the rear (close to the reciever) the front pops up a pretty good ways.
I plan on milling off about .005" off the rear of the rib to get it away from the reciever.
At this time should I try and straighten out the quarter rib a little?
I plan on milling off about .005" off the rear of the rib to get it away from the reciever.
At this time should I try and straighten out the quarter rib a little?