Ruger Forum banner

1 - 12 of 12 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter #1
My speed six 9mm gets really hard to turn but only in certain places. Others are smooth as butter and accurate. When this happens it is also hard to open. Any ideas on what is happening?
 

·
Corps Commander NGV
Joined
·
4,550 Posts
Is the ejector rod bent or the crane sprung? Is the revolver squeaky clean and well lubricated? Did this just start happening?
 

·
Registered
Joined
·
74 Posts
My 9mm Speed-Six doesn't like certain moon clips. Some seem to be too thick and bind the cylinder. Maybe that's the problem.
 

·
Registered
Joined
·
10 Posts
Discussion Starter #7
It does this loader or unloaded. It will work fine for a few complete cylinders then start binding. When it does it it hard to open as well. If I Open it then close back it may be just fine again for a while. Haven't noticed it being certain holes.
 

·
Registered
Joined
·
18 Posts
My SP 101 (.357) will bind if it gets the least bit of powder/residue under the ejector/cylinder. Keep it clean and dry and she works fine.
 

·
Registered
Joined
·
10 Posts
Discussion Starter #11
Thanks everyone. I will try all the above. I hadn't thought about the ejector rod at all.
 
1 - 12 of 12 Posts
Top