Ruger Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
40 Posts
Discussion Starter #1
I have the vortex 3.5 x- 10 x 50mm on my AR556 350 Legend with the vortex one piece base that sets to high and will not hold scope from sliding every time I go to range and shoot it slides back about .1 to .2 of a inch not the same every time I have tighten it more than any scope that I have installed in the past fifty years this is my first AR type Rifle,
Question is there any tricks to keep it from moving and sense I have to raise my head to see through I'm thing of getting lower rings looks like I could go down about .3 be fore the scope hits .
I am thinking of two separate rings this time. what you think?
Thanks
 

·
Registered
Joined
·
423 Posts
Vortex Pro Series rings, high providing it clears your hand guard. Scope is overkill for a short range hunting caliber.
 
1 - 2 of 2 Posts
Top