[zacklou]

Good afternoon all.

I bought my SR9 in June and have shot four times...about once a month or so.

My last trip to the range was great and my accuracy is getting much better. However I am shooting low, about 3 inches. The targets I were using were a little bigger than a normal 8.5 / 11 sheet of paper. For the most part the shorts were centered but again low. I've read some threads here but I am still a little bit confused. To adjust I was turn the screw on the rear site counter clockwise correct? Also with me shooting about three inches low how much do yall suggest turning the screw?

Thanks allot, I really appreciate your time and help.

 

[jlh820]

Here's a thread I started a while back that might help you. Take a look at this and see if it might help.

http://rugerforum.net/pistols-revolvers/58286-pistols-flinching-snapcaps.html#post700507

 

[Gstan1919]

Welcome from CT.

Counter clockwise would be correct.
I would start with one notch at a time on the adjustment screw until you are on target.

Hope this helps.