Ruger Forum banner
1 - 3 of 3 Posts

· Banned
359 Posts
Discussion Starter · #1 ·
I'd like to install a red dot reflex sight on my 10/22 to use in steel matches, but be able to remove it using a QR mount when using my iron sights for targets. The rear Tech-Sight uses up the rear two scope mount holes. Is there a short Pic rail that I can install on the receiver using only the front two mount holes?
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.