Ruger Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
581 Posts
Discussion Starter #1
I've watched all the videos on YouTube on disassembly/reassembly of the SP101, but can't find any information on the model 5720
(spurless). Even the instruction manual that came with it shows how to do a spurred hammer.

If anyone can point me in the right direction, I would appreciate it greatly.
 

·
Retired Moderator & Gunsmith
Joined
·
16,160 Posts
Ruger6, Pull the trigger until the hammer is far enough back to grab. Grab the hammer and pull it all the way back then insert a pin in the hammer strut. From there, the instructions should track just fine.
 

·
Registered
Joined
·
529 Posts
Hello. I have the spurless Hammer model and find the disassembly to be the same process. Maybe I’m not understanding your specific question? If your talking about the hammer spring step, I just pull the trigger far enough to get my thumb under the hammer and pull it back until I can insert the pin to release the spring. Hope this helps! Good luck.
See Iowegan answered your question before me!
 

·
Registered
Joined
·
581 Posts
Discussion Starter #4
Thanks lowegan and sixgun100, I was thinking along those lines, but wasn't 100% sure.

Much appreciated!!
 
1 - 4 of 4 Posts
Top