Ruger Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
Anyone know how to clean SR22 Pistol firing pin and extractor assembly?
I want to remove and clean the firing pin and extractor.

I have searched the internet high and low and cannot find any information on how to remove the firing pin and extractor block for cleaning and maintenance.

Anyone have a link or steps to do this?
 

·
Registered
Joined
·
5 Posts
Discussion Starter · #3 ·
AquaHull,
Thanks for the link however that does NOT show how to disassemble the firing pin block or extractor assembly.


Anybody else?
 

·
Registered
Joined
·
1,074 Posts
joz
I'm taking a guess here after looking at the expolded veiw. I think you're going to have to remove the roll pin in the rear of the slide to get at the parts you want. But as I said this is only a guess. Take a look at the expolded view your self and see what you think. Post how you finaly make out
George
 

·
Registered
Joined
·
197 Posts
Yup, the slide cross pin #49 in the X View should do it, but it looks like all that stuff is spring loaded.

Consider disassembly inside a plastic bag.

The parts involved don't require fitting at Ruger so it should be possible

The link I gave is for the other half of the gun, I saw firing pin something and said good enough:(
 
1 - 5 of 5 Posts
Top