Ruger Forum banner
1 - 1 of 1 Posts

· Registered
209 Posts
Discussion Starter · #1 ·
I've owned my SRH for over 20 years. Whenever I disassemble the revolver, when it came to the cylinder, I've always removed the two steel balls (cylinder retaining balls KE03000) in order to thoroughly clean everything.

I was watching some You Tube videos today, and in several they claimed the balls will not come out of their recess in the crane. I don't recall the balls being pinned or held in by anything.

Just wondering if anyone else noticed this.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.