Ruger Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
Hello, I purchased a very slightly used ss SR9 a few days ago. I went out the day I received it and put 150 rounds through it with no problems other than the sights were horribly off and I didn't have tools to adjust them either ;(... this afternoon I field stripped it and did a complete clean job on the pistol .. it had been very slightly used.....after I put it back together and was admiring the new shiny addition we had in the family I noticed that there's a gap in between the slide and the body of the gun towards the front . it's a nice fit all the way from the rear forwards to about 2 inch's from the front. gap is about 1/8th of an inch and you can look in and see the spring slightly.. is this normal ?? ser. # is 330-6 series.
Thank you
 
1 - 1 of 1 Posts
Top