Ruger Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
44 Posts
Discussion Starter · #1 ·
OK, I did the searches and did not come up with any solution to this that I liked. Specifically I don't want a 4X scope and I don't want a stack of adaptors to cantilever the scope. What I want is a UTG 30mm SWAT 3-12X44 Compact IE Scope that fits in the factory case. What I need is a scope rail that cantilevers back towards the stock. Nothing drastic but a couple inches would work fine. It seems everyone is making concession by using quick release rings. Is there such an animal or I going to have to put up with these poor choices like everyone else. Thanks for your time.
 

·
Registered
Joined
·
45 Posts
I had the same problem. And I asked on a few forums for a solution and found no real help

But after persisting and searching and using a slew of different key word searches I foumd this:

Amazon.com: Airgun/.22 Bi-directional Cantilever 1" Ring Mount: Sports & Outdoors

Works like a charm and brings the eyepiece back about 1.5 inches.

The thing is solid as a rock and hasn't moved on the rail at all after 600rds.

I found similar mounts for up to $80 and even more. I opted to try this inexpensive one first and planned to return it it it was no good.

Works fine. I'm keeping it.
 

·
Registered
Joined
·
44 Posts
Discussion Starter · #3 ·
Thanks Mickey I will give it a try. Be safe!
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top