Ruger Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
68 Posts
Ultimately this is your build and you should do what you prefer, but I can give some input on the KIDD Trigger Job Kit

The installation was a breeze, and the result was fantastic for an $89.00 investment. Night and day difference from the stock factory trigger.

For the price and the ease of installation I would highly recommend it.

Hope this helps!
 

· Registered
Joined
·
68 Posts
I was unaware of that kit... I thought when people said 'Kidd Trigger' they were talking about the complete one with two stage trigger...

There is a testimonial on that page that says it's as good a S&W revolver...not accusing anyone of lying but I am mighty skeptical on that one...

It doesn't seem to have an adjustable sear...maybe it does and I don't know it...

I am curious to know what the pre-travel is on it and if the slack can be taken completely out...

I have the power custom adjustable sear and VQ target hammer and installed my own post travel screw...results are good...no pre or post travel...pull is about 50% of factory...most of the creep is gone but not 100%...

I have no idea how mine compares to the Kidd kit but prices are similar...and mine fits the aluminum housing fine but I also had a shim kit from triggershims.com to go with it...

I don't think you can beat that Kidd kit for $89 since it comes with
I am very pleased with it's result so far, it definitely cut the pull down 50% from stock. They market that the pull will be just under 2lbs and I am happy with that.

So far everything I have purchased from KIDD has lived up to my expectations, the only thing I have left stock is the receiver and bolt. =)
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top