Ruger Forum banner
1 - 1 of 1 Posts

· Registered
290 Posts
Discussion Starter · #1 ·
I have a SR9C and would like to cut about 3/8" off the bottom of the floor plate. This is on the 10 round magazine and need some idea of what would be the best way to do this, hack saw, dremmel, saber saw etc. The gun fits my hand with the extension floor plate, but so it does't stick out under my shirt I think is should be a little shorter. Has anyone done this?
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.