Ruger Forum banner
1 - 1 of 1 Posts

· Registered
7,584 Posts
Discussion Starter · #1 · (Edited)
How would one remove an LCR barrel from the shroud? It's step one of disassembling the forward crane latch, no roll pin like S&Ws.

I thought about a bolt run through, with rubber and metal washers to grip the ends of the barrel. Or tapping in a strip of wood, then "unscrewing" the wood would unscrew the barrel. And would it be right or left hand thread? I feel sure it is threadlocked, too.

Is there a common tool for the job?

Just curious. I have spare springs for both of my LCR latches, just would not be sure how to replace one, if ever.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.