Ruger Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
I had a little trouble finding info regarding mounting the WEIG A Tinny mount on my New Model Blackhawk. (Their own customer service rep was unsure) Turns out the mount for Ruger Revolvers with adjustable sights works just fine.
There is a very slight gap toward the front of the mount 1/16” that is purely cosmetic and you have to look very close to see it. The mount is rock solid with my Burris FF 3 attached. Be sure to follow instructions re: degreasing and locktite.
Have several hundred hot 357 loads through it and it holds zero perfectly.
 

·
Registered
Joined
·
34 Posts
Weigand has an installation video on their web page. According to the video, you should not have a gap between the front of the mount and the frame. Check it out.
 

·
Banned
Joined
·
1,336 Posts
I made a "tinny"-style mount to fit my Single-Ten, which is an extremely close copy to the Blackhawk. I have a milling machine, which made the job a fun thing. I then installed a Burris red-dot. I have no gap whatsoever at the front of adapter. Since there is very little felt-recoil from the .22 LR's it is extremely solid.
 
1 - 5 of 5 Posts
Top