Trijicon RMR / SRO, Holosun 407c / 507c Mount for Ruger Revolver

Enhance your Ruger Revolver with the Evolution Gun Works Mount, designed for Trijicon RMR/SRO and Holosun 407c/507c. Lightweight, durable, and easy to install!

egwguns.com

 

Greetings and salutations, are you just popping in for your inquiry or might you be hanging out for further discussions?

 

Thanks for response
looks like EGW may solve my problem
will look st them further

 

Any Single Six mount works on the Super Wrangler. I just put the discontinued Weaver on mine.

 

Yea but is a Super Wrangler mount the same as a on a Wrangler?

 

no

 

if it takes the same rear sight as a single six then the Alchin GP100 micro mount will fit.
*Single Six , Single ten , Blackhawk and GP100 share the same rear sight.
Cross reference part numbers.

** This Mount is for Reflex sight red dots with the "Docter " footprint =Burris FastFire, Vortex Venom, Viper, and similar **

Ruger GP-100 micro mount

Upgrade your GP‑100 with Allchin’s ultra‑low micro mount. Fits RMR, SRO, Holosun, C‑More STS/RTS2. USA‑made, rock‑solid, trusted by competition shooters.

allchingunparts.com

Happy Shootin!
Petey

Single Ten

 

I tried the EGW mount on mine. It shot very low and I ran out of "up" adjustment long before I was able to get a zero.

I took it off and have yet to get back to it. It needs a little milling to bring it down to the point I can zero it.

From my experience, I can't recommend it but each gun is different so your luck may be different than mine.

 

If you need it milled i will do it for free and duracoat it black for you

 

Very kind offer TSW. I wish I had recorded how much low it was when the adjustment ran out. I know I was shooting at 10 yds and I remember it being quite a bit low....2"?....but I'm unsure. I'm thinking that it would be helpful since then I could do some math to figure out how much the mount had to be "tipped" or milled on the front contact area of the base. Basically have to ramp the base of the mount.

I thought I had a way but it would not be as neat as a pro would do it for sure. If I could get some numbers for you in the relatively near future would you be still be interested?

I did put some Williams sights on it which really helped my accuracy. I've shot it enough now that I think that there is a little more inherent accuracy left in the gun that I'm not able to get with opens.

Have a great day my friend.

 

any thoughts on vendors etc

Buy or decide on the sight you want first then find the base that interfaces.
Some sights mount to Weaver and there are 3 or four different "footprints" for direct mounting.

 

Good advice but my education in red dots told me not all sights have mounts that fit so be weary of your sight choice. It's easier to replace the sight than the gun.